Kuumakse al. Range of Batteries Charged:
Individually or linked:
PAGlink HC-PL94T Model 9306
PAGlink HC-PL150T Model 9313
Individually:
PAG L96e Model 9310A
PAG L96T Model 9305A
Battery Connectors: 2 x Gold Mount.
Main Charge Program:
Li-Ion Intelligent Parallel Charging program: maximum output 6A at 16.8V (100W approx.).
PAGlink Charging:
Up to 8 PAGlink batteries per channel may be charged. Batteries can be in any state-of-charge. The most-discharged batteries will be given a higher charge priority. Fully charged batteries stop accepting charge automatically and independently of other batteries.
Recovery Charge Program:
If a battery will not accept charge, and is indicated as absent (ABST) on the charger display, a Recovery Charge Program can be initiated by two presses of the front panel button, which will enable the battery to be charged. Additionally, the charger will automatically recover a Li-Ion battery where the output has been shut down.
Self Test Program:
Monitors the battery under charge, monitors the charger’s own functions, and shuts down to a safe condition should any tests fail.
Mains Input:
100V to 265V AC. Frequency 50-60 Hz.
Maximum consumption 220W.
Output Protection:
Protected against short circuit and excess battery voltage.
AC Mains Failure Protection:
Should mains failure occur during a charging program, or whilst the charger is connected, it will shut down to a safe condition.
User Interface:
The charge status of each PAGlink battery is indicated by its own display. The different stages of the charging process are indicated for each channel on the charger’s LCD screen. The charger is fully automatic in operation.
Operating Temperature Range: 0ºC to +40ºC (+32ºF to +104ºF).
Dimensions:
Height: 75mm (3”).
Width: 220mm (8.6”).
Length: 190mm (7.5”).
Weight: 1.4kg (3lbs).
Typical 94Wh Battery Charging Times:
1 battery: 2hrs 30mins
2 batteries: 3hrs
4 batteries: 6hrs
6 batteries: 9hrs 30mins
8 batteries: 11hrs 45mins
16 batteries: 24hrs
The times given are for fully-discharged to fully-charged 94Wh batteries equally distributed across both channels. 150Wh batteries will take 50% longer.
Camera Power Supply:
Suitable for powering cameras that can accept a 16.8V input.
Operation:
The camera power supply function is operated by pressing and holding the Camera PSU button on the charger’s front panel for 1 second. Charging is suspended whilst the power supply is in use.
Output: 16.8V DC. Maximum current 5.5A (90W).
Output Connector: XLR4F connector (pin 1 neg. pin 4 pos).
