The Tilta Silicone Protective Cover Power Kit for the DJI Osmo Pocket 4 in celadon white is a five-piece silicone set. To the basic four — gimbal head, body, screen and extension handle — it adds the cover for the battery handle, so the whole rig is covered, including the part you hold most. Each cover is moulded for its own place: microphones, joystick, card slot and charging port stay clear and the screen still rotates. The wave texture grips and the silicone absorbs knocks.
Plus a cover for the battery handle
The Power Kit is the Base Kit plus a fifth piece — the cover for the battery handle. That completes the coverage of the whole rig, including the part you hold most and that wears fastest. The handle gets the same wave texture as the body, so the grip stays consistent.
Every piece moulded for its own part
These are not a one-size sleeve — each cover is moulded for one specific part of the Pocket 4. The microphones, card slot, joystick, buttons, lanyard hole and charging port all stay clear, so you never have to take the camera out. It still fits the official handle and other DJI accessories.
The screen still rotates freely
The gimbal cover is cut away so that it never reaches into the path of the screen. Rotating between portrait and landscape and swiping across the display work exactly as they do without it, and the power button is where your thumb expects it. The cover can therefore stay on all the time, not just while travelling.
Soft silicone instead of a hard shell
Silicone absorbs and spreads an impact, where hard plastic passes it straight on into the camera body. The material is elastic — twist it, squeeze it, and it springs back to shape without stretching or staying deformed. There are no sharp edges, so the camera does not chafe in the hand and your fingers do not slide off it.
Diagonal anti-slip pattern
The back of the body cover and of the handle cover carries a diagonal wave texture. The camera holds in your palm even one-handed above your head, with wet hands, or in gloves in winter. The pattern also hides fingerprints, so the cover still looks clean after days in a pocket.
Three colours you can mix
The set comes in lilac purple, celadon white and sand beige. Because each cover is a separate piece, you can swap them between sets and build your own combination — a white body with a beige head, for instance. The colour runs through the material, so it does not rub off.
The lens cap will not get lost
The gimbal cover also caps the lens, so you take it off before shooting. To stop it ending up in a pocket or under a car seat, it has a lanyard attached — pull it off and it simply hangs from the camera. Putting it back is a single move, even with your other hand full.
- Silicone Protective Cover Base Kit (4 pieces: gimbal head, body, screen, extension handle) – 1×
- Silicone cover for the Osmo Pocket 4 battery handle – 1×
- Compatibility: DJI Osmo Pocket 4 (does not fit the Osmo Pocket 3)
- Number of pieces: 5
- Material: silicone
- Colour: celadon white
